|
联 系 人： 胡锋
电 话: 0411-87300505
传 真: 0411-87305556
手 机: 13940906200
邮 箱: fenghu@chjtech.com
地 址: 大连市经济技术开发区淮 河中三路5号 |
|
|
|
|
| SD-3000II |
| |
| This rework system is designed to remove most SMT components like QFPs, SOPs, PLCCs SOJs, PGAs, BGAs, Connectors and other chips. It does not require any special nozzles or additional accessories. Built in timer to prevent overheating of board and component. The hot air nozzle has an adjustable motion range of up to 50mm per axis. |
- Can handle most SMT parts of up to 50mm square without requiring different nozzles.
- Can remove SMT connectors by setting a single axis motion.
- The built in timer enables to prevent damage of PCB and near by parts caused by over heating.
- Anybody can use this system without difficulty doe to the simplified programming.
- Compact and light weight.
- Low cost, highly efficient.
- Can rework the micro components like 0603
|
|
|
|
| |
REWORK OF MICRO COMPONENT |
|
| |
|
|
 |
|
 |
| |
|
|
| Heating Method |
HOT AIR NOZZLE -4mm, 350 Watts |
| Airflow Rate |
1.5L - 12L/min in 8 Steps |
| Air Pump and Vacuum |
Internal, Does not Require Shop Air |
| Nozzle Motion Range Maximum |
X and Y Motion=50mm, Z=25mm |
| Temperature Control |
Analog with Digital Readout for 260 to 600 Degrees C |
| Timer Control |
Analog with Digital Readout for 5 - 500 seconds |
| Max.PCB Size |
Throat Depth=420mm, Width=Any Size |
| Power Consumption |
100,120, or 230VAC, 350 Watts |
| Dimensions |
300mmW x 310mmHx 450mm D |
| Weight |
9kg |
|
| |
OPERATION FOR REWORK OF MICRO COMPONENTS |
|
| |
- Set the Knob of X & Y in 1 (reading) and set the Knob of BLOW in 1-2 With the Power "ON", the NOZZLE is inclined forwards. Observe the target component with the optional MONITOR& CAMERA and remove or place the component.
- The SMT PIN is available to assist in the removal and placement of the micro-components.
|
- Vacuum Pick (Tweezer)
- 3 Suction Pads (Cups) for Vacuum Pick (Tweezer)
- 5 Filters for Vacuum Pick (Tweezer)
- Base Plate with 430mm x 300mm
- 2 for PCB Holder Small (P/#H-1)
2 for PCB Holder Large (P/#H-2)
- Base Plate Stand (P/#S-1)
- PCB Support Pin (P/#H-3)
- Metal Frame (P/#20-10-10)
|
- Monitor & Camera to Assist in rework of Micro Components
- Auxiliary Holder for Small Boards
- SMT PIN for Rework of Micro Components
|
- Fujitsu, Fuji Electricals, Hitachi, Juki, JVC, Matsushita, Meidensha, Meteorlogical Agency Mitsubushi, NEC, National Observatory, Omuron, Oki Electricals, Panasonic, Sanyo, Sharp, Sony, Sumitomo, Toshiba, Yasukawa, Yokogawa and others
|
| |
DOWNLOAD CATALOG & MANUAL |
|
|
|
|
|
|
|
|
MANUAL : 
